OKUMA E4809-770-144-A主電路板模塊
雖然地址不必是連續的，但沒有兩個PQM可以具有相同的地址，否則將存在導致錯誤的沖突。通常，添加到鏈接的每個PQM將使用下一個更高的地址，從地址1開始。?波特率：輸入每個端口的波特率：1200、2400、4800、9600或19200波特。RS485通信鏈路上的所有PQM和計算機必須以相同的波特率運行。最快的響應速度為19200波特。如果噪聲成為問題，請使用較慢的波特率。數據幀由1個起始位、8個數據位、1個停止位和一個可編程奇偶校驗位組成。波特率默認設置為9600。?奇偶校驗：輸入每個通信端口的奇偶校驗：EVEN、ODD或NONE。RS485通信鏈路上的所有PQM和連接它們的計算機必須具有相同的奇偶校驗
Although addresses do not have to be sequential, no two PQMs can have the same address or there will be conflicts resulting in errors. Generally, each PQM added to the link will use the next higher address, starting from address 1. ? BAUD RATE: Enter the baud rate for each port: 1200, 2400, 4800, 9600, or 19200 baud. All PQMs and the computer on the RS485 communication link must run at the same baud rate. The fastest response is obtained at 19200 baud. Use slower baud rates if noise becomes a problem. The data frame consists of 1 start bit, 8 data bits, 1 stop bit and a programmable parity bit. The BAUD RATE default setting is 9600. ? PARITY: Enter the parity for each communication port: EVEN, ODD, or NONE. All PQMs on the RS485 communication link and the computer connecting them must have the same parity
轉載請附上此鏈接：http://www.wzljsf.com/
