Vibro-meter 200-582-500-021振動傳感器
連接選項卡對于CI854/CI854A，可以配置到UnitStatus的連接。有關更多信息，請參閱Control Builder M聯機幫助。機組狀態選項卡有關機組狀態選項卡的信息，請參見Control Builder M在線幫助。PROFIBUS主參數的自動計算定義總線參數的最簡單方法是讓系統計算它們。您只需將–節點地址、–波特率和–線路冗余模式設置為所需值。無需更改所有其他參數。表3中標有*的參數在下載過程中根據從屬裝置的實際配置自動計算。自動計算可確保所有計算參數都處于安全狀態。這意味著還必須考慮手動更改。因此，不會將實際設置更改為更快但不安全的值。
Connection Tab
For CI854/CI854A a connection to the UnitStatus can be configured. For
more information refer to Control Builder M online help.Unit Status Tab
For information on the Unit Status tab please refer to Control Builder M
online help.
Automatic Calculation of PROFIBUS Master Parameter
The easiest way to define the bus parameters is to let the system calculate them. You
only have to set:
– the node address,
– the baudrate and
– the line redundancy mode
to the required values. All other parameters don’t need to be changed. The
Parameters marked with a * in Table 3 are calculated automatically during
download depending on the actual configuration for the slave units.
The automatic calculation ensures that all calculated parameters will be on the safe
side. This means also manual changes have to be considered. Therefore no changes
of the actual settings in direction to faster but insecure values takes place.
