Vibro-meter 200-595-031-111 VM600 CPUM模塊
要獲得PROFIBUS主參數的優化值，請將參數計算方法設置為基于最小值。自動計算現在將重新計算所有參數。結果是您可以為配置的從設備達到最快的循環時間。如果您的設備需要特殊設置，請首先按照上述步驟進行操作。在第二次運行中，對特定參數進行手動調整，將參數計算方法切換為基于實際值，并重復自動計算。默認值在設置PROFIBUS DP-V1波特率時，以下默認值可用作指導。這些值取自PROFIBUS標準，并根據CI854/CI854A的需要進行修改：一些PROFIBUS從設備，如CI830和CI840，與上述參數設置不兼容。在這種情況下，不能使用上述參數。另請參閱您正在使用的PROFIBUS從屬類型的文檔。
To get the optimized values for the PROFIBUS master parameters set the
parameter Calculation method to Minimum value based. The automatic
calculation will now recalculate all parameters. The result is the fastest possible
cycle time you can reach for the configured slaves.
If you have devices that need special settings then first proceed as described
above. In a second run do the manual adjustments to the specific parameters,
switch the parameter Calculation method to Actual value based and repeat
automatic calculation.Default Values
The following default values may be used as guidelines when setting up the
PROFIBUS DP-V1 baudrate. The values are taken from the PROFIBUS standard
and modified for the CI854/CI854A needs:Some PROFIBUS slave units like CI830 and CI840 are not compatible with the
parameter settings shown above. In such a case, none of the parameters above can
be used. Please see also the documentation for the PROFIBUS slave type you are
using.
