Vibro-meter 200-595-100-014 200-595-072-122 VM600 CPUM
Control Builder M僅支持1.5 Mbit/s的默認值。通過添加新的CI854/CI854A硬件單元來設置默認值。如果更改波特率，其他參數的當前值將不會更改。如果您還想使這些參數適應新的波特率，則必須手動進行特殊設置對于某些設備，需要對PROFIBUS主參數進行特殊手動調整。RLM01、中繼器、MediaConverter如果僅使用一個段或短光纖連接，則無需進行調整。PROFIBUS主參數的自動計算已經考慮到了這一點。如果PROFIBUS由多個段組成或使用長光纖連接，則必須根據供應商提供的值調整設置。光媒體時隙時間（TSL）請參考供應商提供的值。ABB時隙時間（TSL）的鏈接設備（1）LD 800P將時隙時間增加約150…500
The Control Builder M supports default values only for 1.5 Mbit/s. The default
values are set by adding a new CI854/CI854A hardware unit. If you change the
baudrate the current values for the other parameters will not be changed. If you
also want to adapt these parameters to the new baudrate you have to do it
manually Special Settings
For some devices special manual adjustments to the PROFIBUS master parameters
are necessary.RLM01,
Repeater, MediaConverter
No adjustment is necessary if only one
segment or a short optical connection is
used. The automatic calculation of the
PROFIBUS master parameters has taken
this already into account. If the
PROFIBUS consists of several segments
or long optical connections are used then
the settings have to be adapted to the
values provided by the supplier.
Optical Media Slot time (TSL) Please refer to the values provided by the
supplier.
Linking Device(1)
LD 800P from
ABB
Slot time (TSL) Increase Slot time about 150...500
