Vibro-meter 600-003 620-001-001-116 VM600 XMV16模塊
看門狗時間PA側的看門狗時間在LD 800P的固件中固定為5秒，與DP側無關。鏈接設備（1）SK2從P&F時隙時間（TSL）增加時隙時間約150…500（2）看門狗時間SK2以透明模式工作。它通過計算的看門狗時間從DP側到PA側。因?yàn)镻A側比DP側慢得多，所以DP側的看門狗時間必須配置為足以滿足PA側的定時約束。因此，將看門狗時間設置為5秒。鏈接設備（1）SK3（PROFIBUS Power Hub有關更多信息，請參閱第59頁的PROFIBUS Power HubSK3。要啟用LD 800P、SK2或SK3支持的12 Mbit/s，需要調整從設備的定時參數。這在將GSD文件轉換為HWD文件期間由設備導入向?qū)ё詣?dòng)完成。如果由于任何原因未使用DIW，也可以使用GSD轉換器工具
Watchdog time The watchdog time on PA-side is fixed in
the firmware of LD 800P to 5 seconds and
independent from the DP-side.
Linking Device(1)
SK2 from P&F
Slot time (TSL) Increase Slot time about 150...500(2)
Watchdog time The SK2 is working in a transparent
mode. It passes through the calculated
watchdog time from the DP-side to the
PA-side. Because the PA-side is much
slower than the DP-side, the watchdog
time on DP-side has to be configured
adequate to the timing constraints on PAside. Therefore set the watchdog time to 5
seconds.
Linking Device(1)
SK3 (PROFIBUS
Power Hub
For more information see PROFIBUS Power Hub SK3 on page
59 To get the 12 Mbit/s supported by the LD 800P, SK2 or SK3 enabled, an adaptation of the timing
parameters for the slave device is necessary. This is automatically done by the Device Import
Wizard during conversion of the GSD file to HWD file. If DIW is not used because of any reason
it can also be adapted by using the GSD Converter Tool
