EPRO PR9268307-100 9200-06121n振動傳感器
EPRO PR9268307-100 9200-06121n振動傳感器中文資料：
EPRO PR9268307-100 9200-06121n振動傳感器注：盡管圖2-7顯示了塑料基板蓋已拆除，但這僅用于說明。無需拆下蓋即可安裝支架。支架就位后，將兩個螺釘（包括在支架中）穿過底板孔的背面插入并擰緊到支架中的螺紋孔中。IC693ACC313嵌入式安裝適配器支架。EPRO PR9268307-100 9200-06121n用于在19“機架內凹入安裝底板。使用四個8-32（4mm）螺釘、螺母、鎖緊墊圈和平墊圈將基板安裝在適配器支架的后面板上。適配器支架使用適用的硬件（建議使用鎖緊墊圈）通過其四個槽孔螺栓連接到19“機架的表面。注意：為了說明，所示的基板已拆下蓋子。安裝支架時無需拆下基板蓋。圖2-7。IC693ACC308前安裝適配器支架安裝尺寸如下圖所示，用于用IC693ACC 308前安裝連接器支架機架安裝10槽底板。EPRO PR9268307-100 9200-06121n
英文資料
NOTE: Although Figure 2-7 shows the plastic baseplate cover removed, this is for illustration purposes only. It is not necessary to remove the cover to install the bracket. With the bracket in place, insert and tighten the two screws (included with the bracket) through the back of the baseplate holes into the threaded holes in the bracket.IC693ACC313 Recessed Mount Adapter Bracket. Used to recess mount a baseplate inside a 19” rack. A baseplate mounts on the rear panel of this adapter bracket using four 8-32 (4mm) screws, nuts, lock washers, and flat washers. The Adapter Bracket bolts through its four slotted holes to the face of the 19” rack using applicable hardware (lock washers recommended).Note: Baseplate is shown with cover removed for illustration purposes. It is not necessary to remove the baseplate cover to install the bracket. Figure 2-7. IC693ACC308 Front Mount Adapter Bracket Installation Dimensions for rack mounting a 10-slot baseplate with the IC693ACC308 Front Mount Adapter Bracket are shown in the following figure.EPRO PR9268307-100 9200-06121n
每 日 展 示
公 司 主 營 優 勢
應 用 行 業
