IBP PCF 0512 J V234 T1 Z105工業鍵盤
1.產 品 介 紹
品牌：IBP
型號：IBP PCF 0512 J V234 T1 Z105
產品說明：工業鍵盤
優勢：供應進口原裝正品，專業停產配件。
2.產 品 詳 情 資 料：
IBP PCF 0512 J V234 T1 Z105此外，如果您只對多點鏈路上的最后一個PLC有問題，則最后一段電纜可能有問題?；蛘撸苍S你可以連接到所有PLC，直到某一點，但沒有超過該點。這也強烈表明電纜部分存在問題。NP ID可能不正確。您可能無法連接，因為您指定了錯誤的SNP ID。IBP PCF 0512 J V234 T1 Z105如果您不確定PLC的正確SNP ID，并想檢查它，您可以將編程器直接連接到PLC的編程器端口，并從軟件的ASSIGN PLC ID屏幕讀取其SNP ID（如上文“使用Logicmaster將SNP ID分配給PLC”所述）。確保將編程軟件的連接方法更改為本測試的Direct。當設置為直接連接時，軟件將與直接連接的PLC通信，而不考慮其SNP ID。IBP PCF 0512 J V234 T1 Z105
Also, if you only have a problem with the last PLC on the multidrop link, the last section of cable may have a problem. Or, perhaps you can connect to all PLCs up to a certain point, but none beyond that point. This would also strongly suggest that there is a problem in a section of cable.SNP ID may be incorrect. You may not be able to connect because you are specifying the wrong SNP ID. If you are not sure of a PLC’s correct SNP ID and would like to check it, IBP PCF 0512 J V234 T1 Z105you can connect your programmer directly to the PLC’s programmer port and read its SNP ID from the software’s ASSIGN PLC ID screen, (as described in “Assigning an SNP ID to a PLC with Logicmaster,” above). Make sure you change the programming software’s connection method to Direct for this test. When set for Direct connection, the software will communicate with a directly connected PLC without regard to its SNP ID.IBP PCF 0512 J V234 T1 Z105
3.產 品 展 示
4.公 司 優 勢
5.關 于 我 們
本篇文章出自瑞昌明盛自動化設備有限公司官網，轉載請附上此鏈接:http://www.wzljsf.com
